spinning problem on varian probe
We are using a Varian300autoSW probe, which had previously worked well with no problems spinning samples. We had switched this probe out with a solids probe for some time and when we put the liquids probe back in, the liquids probe was no longer able to spin samples. We are well aware of all of the problems with dirt in the upper bore tube or on the spinner causing problems with sample spinning and have taken to time clean each of these throroughly. We believe that somehow there is a problem with the VNMRJ (2.2D) software setting that occured after switching probes. The reason we think this is that we have an old sundisk we previously used for this instrument. When I hook up the old sundisk (vnrmj 1.1D), the sample spins with no problems. Something we think might also be relevant is the CPU running VNMRJ 2.2D reports an error message in the terminal screen: 'masSpeedWrap.c' line: 139,
* Speed Controller had problem with 'S' command.
This message is clearly about the solids probe. We've searched the vnmrj manuals and throughout the internet but cannot find a solution for our VNMRJ2.2D computer not being able to spin samples or what is causing the MAS error message.
If anyone has any suggestions on how to proceed, we would be extremely grateful
Thanks
Quinn Best
Check if somebody has answered this question on
NMRWiki QA forum