NMRPipe: re-integrate peaks
 

NMRPipe: re-integrate peaks

Hello,

I am familiarizing myself with NMRPipe and I have a question similar to the one already asked (http://qa.nmrwiki.org/question/145/w...-data-analysis). I want to perform assignments in one spectrum and transfer them to another one. I have used ipap.tcl as advised, but the peak heights got also propagated into the new file. Is it possible to re-read the heights from the spectrum for the generated assignment table?

The syntax I used was:ipap.tcl -specName1 assigned.ft -specName2 unassigned.ft -inName1 assignments.tab -assName assignments.tab -jy 0

Thank you,Vitaly



Check if somebody has answered this question on NMRWiki QA forum